Payment & Shipping Terms:
|Product Name:||Adjustable Full Body Harness Fall Protection Equipment Two Big Hook Along With Buffer Bag||Type:||Safety Belt|
|Item:||Safety Tools||Application:||Industrial Safety Belt|
|Work Type:||Area Work||Feature:||Fall Protection Equipment|
|Material:||100% Polyester||Color:||Red, Yellow, Blue Or According To Your Needs|
cable lug crimping tool,
hydraulic lug crimping tool
Adjustable Full Body Harness Fall Protection Equipment Two Big Hook Along With Buffer Bag
|Width of belt||42mm||Thickness of belt||1.6mm|
|Diameter of rope||14mm||Length of rope||1500mm|
|Overall Rally||15KN||Parts Rally||22KN|
|Material of the belt||Polyester||Material of the rope||Polyester|
|Period of use||3years||Anti-aging||yes|
Seat belts in the course of note:
1. Seatbelt use must be made before a full safety inspection, wearing correct, whether all the various parts of the clasp fasten clamp failure discovery activities, components, rope breakage or deterioration should immediately stop using scrap replacement.
2. Use to keep clean after use should be placed on a shelf stored in dry and ventilated warehouse, room temperature 0-30 °C, relative humidity less 80 °C, should not be exposed to high temperatures above 120 °C, fire, acid, and there is an acute , sharp hard objects, not exposure to sunlight.
3. Polyester or nylon belts must be used year after a comprehensive inspection and draw one percent of the appearance of doing the most good tensile testing, the overall static tension of not less than 12KN, each part or material deformation without breaking qualified, sampling over security Do not use tape, tape to use for a maximum of three years, if found to be abnormal early retirement. High-strength polypropylene webbing after one year should be given priority if scrapped.
4. Disclaimer: old products, failure load when the main belt or safety rope batch of low-15KN always replace the seat belt should be promptly discarded.
How to properly wear full body harness?
Step One: Check the back of the seat belt holding the seat belt buckle D-pad to ensure no ribbon entwined.
Step Two: Start wearing a seat belt seat belt over the arms to the shoulders. Ribbon is no guarantee that all tangles, freedom hanging. Straps must remain vertical, not near the center of the body.
Step Three: The leg grab leg webbing belt, they are connected with the buckle webbing on both sides of the hips. The extra length of webbing penetration adjustment ring
Step Four: The chest strap webbing connected together by wearing sleeve fastener. Chest strap must be in place 15 cm below the shoulders. The extra length of webbing penetration adjustment ring.
Step Five: Adjust the seat belt shoulder: from the shoulder began to adjust the body webbing straps ensure high leg just below the buttocks, back D-ring located between the shoulder blades. Legs: leg webbing then adjust reach and try to do one leg squat, using the same adjustment on both sides of the legs have webbing length. Chest: The chest webbing to cross in the middle of the chest, and the left hand around the bottom of the breastbone three guiding a wide distance. Wear appropriate body harness and adjust the impact force can be effectively decomposed into the body, and to provide some support and fall suspended the rescue.
Contact Person: Ms. Judy